Rozdíly

Zde můžete vidět rozdíly mezi vybranou verzí a aktuální verzí dané stránky.

--- cisco:adsl_nastaveni [23.04.2010 07:40]
mtalma
+++ cisco:adsl_nastaveni [13.03.2020 18:43] (aktuální)
@@ Řádek 38: / Řádek 38: @@
 </code>
+===== PPPoE =====
+<code>
+interface Vlan1
+ ip tcp adjust-mss 1412
+ exit
+interface ATM0
+ no ip address
+ no atm ilmi-keepalive
+ dsl operating-mode auto
+ exit
+interface ATM0.1 point-to-point
+ pvc 8/48
+  pppoe-client dial-pool-number 1
+  exit
+ exit
+interface Dialer1
+ description PPoE
+ ip address negotiated
+ ip mtu 1452
+ ip nat outside
+ ip virtual-reassembly
+ zone-member security WAN
+ encapsulation ppp
+ dialer pool 1
+ dialer-group 1
+ no cdp enable
+ ppp authentication pap callin
+ ppp pap sent-username O2 password O2
+ exit
+dialer-list 1 protocol ip permit
+ exit
+</code>
+===== PPPoE Cisco 1751 =====
+<code>
+vpdn enable
+!
+vpdn-group 1
+ request-dialin
+  protocol pppoe
+interface Gi0/1
+ no ip address
+ speed auto
+ pppoe enable
+ pppoe-client dial-pool-number 1
+interface Dialer1
+ ip address negotiated
+ encapsulation ppp
+ dialer pool 1
+ dialer-group 1
+ ppp pap sent-username O2 password 0 O2
+dialer-list 1 protocol ip permit
+Router#sh ip interface brief
+Interface                  IP-Address      OK? Method Status                Protocol
+Ethernet0/0                10.10.204.60    YES NVRAM  up                    up
+FastEthernet0/0            unassigned      YES NVRAM  up                    up
+Serial1/0                  unassigned      YES NVRAM  administratively down down
+Virtual-Access1            unassigned      YES unset  up                    up
+Dialer1                    46.13.xxx.xxx   YES IPCP   up                    up
+</code>