{{page>:menu}}
====== Huawei ======

===== nastavení ip =====
<code>
<Quidway>system-view 
[Quidway]interface Vlan-interface 1
[Quidway-Vlan-interface1]ip address 172.30.0.17 255.255.0.0
[Quidway]quit
<Quidway>save 
The configuration will be written to the device.
Are you sure?[Y/N]y
 Please input the file name(*.cfg)[flash:/vrpcfg.cfg]:

Now saving current configuration to the device.
Saving configuration. Please wait...
....
Configuration is saved to flash memory successfully.
 Unit1 save configuration flash:/vrpcfg.cfg successfully
</code>

===== zobrazení konfigurace =====
<code>
<Quidway>display saved-configuration
<Quidway>display current-configuration
</code>



===== uživatel =====
<code>
[Quidway]local-user datron 
New local user added.
[Quidway-luser-datron]level 3
                      authorization-attribute level 3 (3com switch)
[Quidway-luser-datron]password simple Heslo123
[Quidway-luser-datron]service-type telnet
</code>

===== sysname =====
<code>
[Quidway]sysname Quidway.14
</code>

===== interfaces status =====
<code>
[Quidway S6503]display brief interface 
</code>

===== routing =====
<code>
[Quidway]ip route-static 0.0.0.0 0.0.0.0 10.10.30.30
</code>

===== trunk =====
<code>
Password:
<Quidway S6503>sys
System View: return to User View with Ctrl+Z.
[Quidway S6503]interface GigabitEthernet 0/0/3
[Quidway S6503-GigabitEthernet0/0/3]port link-type trunk 
[Quidway S6503-GigabitEthernet0/0/3]port trunk permit vlan 1 3
</code>


===== vty =====
<code>
[Quidway]user-interface vty 0 4
[Quidway-ui-vty0-4]user privilege level 3
[Quidway-ui-vty0-4]authentication-mode scheme
</code>

===== access vlan =====
<code>
[Quidway]interface Ethernet 1/0/2
[Quidway-Ethernet1/0/2]port access vlan 2
</code>

===== web rozhraní =====
<code>
<Quidway>system-view 
[Quidway]web set-package http3.1.3-0043.web 
</code>

===== plánovaný reload =====
<code>
<Quidway>schedule reboot <delay|at>
</code>

===== snmp =====
<code>
snmp-agent
snmp-agent community read datron
snmp-agent sys-info version v1
</code>

===== edge port =====
  *ve výchozím stavu jsou všechny porty v režimu edge. Pro porty v trunku je dobré toto vypnout.
<code>stp interface Gi1/0/1 edged-port enable</code>
<code>
system-view
interface Gi1/0/1
stp edged-port enable
</code>